• Notice regarding image hosts and attachments. See here.

Black screen

Associate
Joined
13 Oct 2011
Posts
209
I just bought a new AMD 955 cpu and I alson switched my board to a gigabyte, I took out my old components then put the new ones in.

After that I done a full re-install of windows, it restarted no problem then I put the drivers on for my board,gfx card, etc. I restart it again then it went to the welcome screen and after that it went black and the mouse cursor was showing but nothing else.

Does anyone know what this might be ? Thanks.
 
Sounds like a bad driver install, please list your components incl. gfx card PSU etc. The only driver I usually install from a disk supplied by the manufacturer is the ethernet but purely to get online.

My components are.

Amd phenom II 955
Gigabyte ga-880gm board
2x4gb kingston hyper x 1600mhZ
Crosair hx 450w psu
120gb kingston ssd
1tb hitatchi hdd
HIS 6950 GFX card
 
Just an FYI. When installing to a SSD it's wise to leave the storage HDD disconnected. Also make sure ACHI mode (not IDE) is enabled in the sata settings of the BIOS.

If you didn't install the OS this way it might be wise to do another reinstall, which should also cure the black screen issue. Yes it does sound like a driver issue, especially as safe mode works ok. Safe mode loads the bare minimum required to get the OS loaded.

Yes I disconnected the HDD and made sure the ACHI was enabled. Hopefully doing a system restore on safe mode then re-installing the drivers will fix the problem.
 
Thanks for the advice honosuseri :) I'm glad I have this forum for help lol. I will be overclocking my cpu once everything is up and running ok, later on I am considering a water cooler to be on the safe side :).
 
It is dangerous and safe at the same time:p if you know what you are doing I think you'll be fine.

I'll be looking into water cooled systems quite a bit before even thinking about buying anything for it:) or I migh just buy a pre built water cooler. But wheres the fun in that;).
 
I was looking into the h100 or thw h80 they both look good, I know custom water cooling is expensive, it is just something to do really. I was looking at ocuk tech lab kits, not too sure what to get.
 
Back
Top Bottom