Brakes binding?

Soldato
Joined
1 May 2003
Posts
3,207
Location
Bucks
Earlier today I smelt what I thought was electrical burning coming from the car when I arrived at work. However a quick search found nothing, but then on driving the car again just now I smelt it again and realised it was the smell of brakes burning.

Now I had some new front disks and performance pads fitted to my MX5 a couple of weeks ago and I noticed on Thursday how the left front wheel was really grey with brake dust compared to the right. I should have thought more into it but didn't and forgot about it.

So on smelling it just now I quickly pulled over to find smoke coming from the front left callipers. I will take it into the garage tomorrow but wondered what it could be and whether it could be something they have done wrong or just something that has 'gone'. I am not sure what pulls the pads back from the disks when you finish braking, but I am guessing it has broken or gone. Is this likely to be a problem fitting or a wear and tear part?

At least this answers why the car has been feeling quite sluggish and very strange when I reversed into my parking space yesterday! Really hope I haven't balls up the new disks and pads too much though? :(
 
Thanks guys.

Well I was not easily able to do any checks myself such as raising the car up or dismantling the brakes, so I took the car back to the garage that fitted the pads and disks.

They did an inspection and removed the caliper and couldn't find anything wrong. So I picked the car up and a few miles later I had the same problem of the brake dragging on the front left and plenty of smoke coming off them when I pulled up :(

So I drove back to the garage later that day and used the brakes hard as I really wanted them to see this 'smoking' for themselves. However when I got there much to my surprise they weren't smoking any more. So off I went thinking it was sorted and crawled back to work in the traffic, only to find the brakes smoking again on arrival!!! So it seems that this is happening when I use the brakes gently in slow moving traffic and not so much when I use them hard.

The car has been back in the garage today and the mechanic has done a complete strip down of the brake unit and still can't find anything wrong, which has been really bugging him. He says that the pads slide beautifully in their slots, that the piston is clean and unmarked and he has also drained the fluids as he thought a line may have collapsed. However their braking machine is still detecting a drag on the left side. He seemed genuinely annoyed that he couldn't locate the problem and give me some definite answers. His suggestion is now to replace the caliper for £110, but he cannot guarantee that this will fix the problem as the current one looks fine in his opinion. So not to sure what to do apart from order a new caliper?

They seem a good bunch and I have used them for many years so I am in no doubt that they are being honest and thorough, its just really annoying not knowing what is going on :(
 
Just had a thought.....is there any chance that the problem could be caused by me having low disks and pads on the rear? The mechanic explained that the cars brake lines are distributed front left to rear right and front right to rear left. As my disks and pads on the front are new and therefore have less movement to travel before they contact the disk compared to the rears, I wondered if this could upset the balance in the bias?
 
Back
Top Bottom