Brick wall on E6400

MaVericK010 · 20 Jan 2008 at 17:39

I seem to have hit a wall at 3.2g, heat isn't the prob as it is aroud 50ish under load.

My rig is:

E6400
Gigabyte GA-P35-DS3L
Geil ddr2 800 ultra low latency
arctic pro 7

Anyone with similar system have a good set of settings?

Thx
Chris

eyetrip · 20 Jan 2008 at 17:55

What FSB, multiplier, and voltages are you using?

Wilst · 20 Jan 2008 at 17:57

Thats about as far as your going to go on stock volts.

MaVericK010 · 20 Jan 2008 at 18:14

FSB 400
multi x8
vcore 1.34
ddr 0.3 (ram is rated 2.1 v)
the rest volts are stock

sulli · 20 Jan 2008 at 18:20

Set the ram to 1:1 multi
up vcore a notch or two and retry
if that fails try upping the mch(chipset) voltage and vfsb a notch.

MaVericK010 · 20 Jan 2008 at 18:24

ram is on 2.00 already, my ram timings are 5-5-5-15

sulli · 20 Jan 2008 at 18:37

Ram should be fine then. have u tried raising the vcore?

Wilst · 20 Jan 2008 at 19:58

I think you just need more vcore. I know all chips are different but for 3.2 i need 1.375 bios which is 1.328 after vdroop. If you think you've hit a wall for another reason then try putting 1.4 or a voltage that is more than enough, test it at that and then turn the voltage down until it becomes unstable. Your temps are good enough that you an afford to turn up the vcore quite a lot.

MaVericK010 · 21 Jan 2008 at 03:44

pk thx for your help peeps! =)