Soldato
Hi,
Was just wondering if some kind sole would measure the compartment where the PSU sits. Specifically the height of it, and also the height from the bottom of the PSU (this is with the PSU mounted to the top of the compartment) to the bottom of the compartment.
Basically I want to see if I could mount a 120.2 rad in this PSU compartment but on its side. So it would be mounted on the side panel, thus wouldn't suck up all the rubbish from the floor. Not sure if there is enough room though.
Was just wondering if some kind sole would measure the compartment where the PSU sits. Specifically the height of it, and also the height from the bottom of the PSU (this is with the PSU mounted to the top of the compartment) to the bottom of the compartment.
Basically I want to see if I could mount a 120.2 rad in this PSU compartment but on its side. So it would be mounted on the side panel, thus wouldn't suck up all the rubbish from the floor. Not sure if there is enough room though.
. Basically I will have the PSU at the top instead of the bottom like that picture shows. Remove the PSU Mounting Plate and then the rad should have around 3cm of clearance. Which now means I am probably looking at getting a 120.3 rad as I wasn't liking the fact a 120.3 rad would have to have gone over the wheels if bottom mounted, bit to fiddly.