Can someone take a look at my CPUZ readings

bushmins · 8 Sep 2011 at 14:42

Im wondering if everything looks ok with these? All i have done is pushed my cpu from 2.4 to 2.8 (in bios). Not changed anything else apart from getting the RAM back to 800 in bios.

Just going to check my bios to see if there was anything else.

My RAM is DDR2 PC-26400C4 800MHz Ultra low latency duel channel. GEIL 800 CL 4-4-4-12 2.1v

MeddlE · 8 Sep 2011 at 14:54

Only thing wrong is your memory timings, you're running 5-5-5-18 instead of 4-4-4-12. You'll have to manually set those in the BIOS, make sure you set the memory voltage to 2.1v.

bushmins · 8 Sep 2011 at 14:55

OK. Thats what i was worried about.
When changing bios i did this. Which was pretty much the same as i did on my old Gigabyte board.

CPU clock speed to 400MHz
DRAM speed to 400/800 - This put the target RAM speed back to DDR2 800.

bushmins · 8 Sep 2011 at 15:05

Is there any way to check my RAM voltages in wondows? Just want to be sure i change the right value in bios.
I noticed that the RAM freq is 400MHz in CPUZ, should that read 800?

MeddlE · 8 Sep 2011 at 15:18

It's in the Voltage Settings part of the BIOS, which is under the Genie section, look for DRAM Voltage Control.

Have a look on Clunk for more on your board.
http://www.clunk.org.uk/forums/reviews/12354-dfi-lanparty-ut-p45-t2rs-living-review.html

Orcvader · 8 Sep 2011 at 15:30

bushmins said:
I noticed that the RAM freq is 400MHz in CPUZ, should that read 800?

DDR = Double Data Rate. 400 is normal, it means your RAM speed is 800mhz