Cant get CPU clocked over 2.35Ghz

[stonedrhino]

yo i manage to get my AMD Athlon 3000+ 2.0ghz at 2.35ghz not much of a change i no, the temps are fine and the system is runnng stable its running at 1.55V which is maximum and the multipler is on a default 10X but if i go to 2.4 it boots to when it loads XP then goes back to the original bootup screen and starts the procces again, am i running my RAM to fast??? i have a ASrock K8-Combo Z with M1653 chip anysuggestions so i can get this clockin higher thx

 

[Rab]

lower your HT to x3 or x4, raise u volts on cpu a LITTLE. Put mem on a divider this may help.
tbh u need 2 read the sticky on OC, if u stuck go bak & read it more.

u dont say what ram ect u running, if value ram or cheap ram, this could b its limit. u say u can boot into windows @2.35 & its stable, that prime stable?
best bet would b 2 start from beginng again, taking it slow & going over the oc sticky, again & again. till u r @ least familar with it

PS! just noticed u volts, if that voltage on cpu, going any higher could cause more probs.