Case project Antecs

[Matt_Hirst]

Just thinking of doing a bit of a case project involving 2 Antec 1000 cases, am wondering if I strip them down and connect together to form some form of cube, or other option is to cut one up and create an underneath enlosure for a water cooling setup.

Anyone got any other ideas?

What is the best route for connecting together the 2 cases, bolts or ??? Also would need some aluminium sheet, what thickness do you think I'll need to form the new top if I bolt the 2 cases together side by side?

regards,

Matt

 

[bigsharn]

Antec 1000s? Never heard of them

best Idea (I think) is have both of them as they are, basically stick them together without the sidepanels and make a cube. I'd say that you'd need no thicker than 1.5mm Alu to hold them together (but it might be worth doing the same at the bottom too), if it seems a bit flimsy just use an offcut to strengthen it at the ends (which is where it would bend or break, if anywhere)

 

[G-Dubs]

Gaffa tape!