ChrystalMark

Associate
Joined
21 Jan 2007
Posts
303
Location
GLENROTHES-FIFE
Hi all....I'm at it now with another little bench. This time we can compare each aspect of our rigs seperately. Again, there is no additional software required to use this bench.....you don't even need to install....just download, unzip and run :)

CRYSTAL DEW WORLD homepage http://crystalmark.info/?lang=en

CRYSTALMARK 2004R2 download http://dl.crystaldew.info/download/CrystalMark2004R2.zip

To bench all aspect of your rig in one go click MARK.
To bench each aspect of your rig seperately click ALU,FPU,MEM,HDD etc.

If you bench with MARK and allow all bench's to complete you can fill out your details on the RANKING page and submit your results by clicking ENTRY.

This is only possible for FULL benchmarks.

I'll update this with my result in a few minutes :)

Best of luck all :)
 
Last edited:
134466b054dc621a.jpg


:/
 
Assumedly if you're going to compare you need to set a standard resolution, my scores on GDI, D2D and OGL are lower than yours (Millwall.FC), but likely because of my 2560x1600 resolution.
 
nice memory score bud, what you runnin'?

Mud said:
Assumedly if you're going to compare you need to set a standard resolution, my scores on GDI, D2D and OGL are lower than yours (Millwall.FC), but likely because of my 2560x1600 resolution.

yes, this is true. The vast majority of users set to 1280x1024 but we could agree on any resolution amongst ourselves.
 

I ran it at 1280x1024 until we can decide on a res that we all should use and will run it again later with cpu at 3.4.
 
khemist said:
I ran it at 1280x1024 until we can decide on a res that we all should use and will run it again later with cpu at 3.4.
O.k cool, 1280 it is. I'll go make a couple of runs now.

Nice desktop :)

update
with single sata partition used for HDD
110335withsata.jpg


with RAMDisk used for HDD
154555withRAMDisk.jpg


I seem to be getting insanely low GDI/OGL scores with this now. :confused:

Need to investigate.
 
Last edited:
Back
Top Bottom