CISCO 5508 Wireless Controller - how do you factory reset
- Thread starter welshboy
- Start date
Associate
- Joined
- 23 Dec 2002
- Posts
- 1,495
- Location
- Under my desk
Hi there,
Assuming that it's not gone over to use SSH instead of Telnet:
1. Console onto the 5508, and power cycle it
2. At the login prompt, type recover-config
3. The controller will reboot and go through the installation wizard
Job done
Assuming that it's not gone over to use SSH instead of Telnet:
1. Console onto the 5508, and power cycle it
2. At the login prompt, type recover-config
3. The controller will reboot and go through the installation wizard
Job done