• Notice regarding image hosts and attachments. See here.

Computer just caught fire!

Soldato
Joined
21 Oct 2010
Posts
2,867
Location
~/
Or at least I think it did. Started smoking so I immediately pulled the power. No obvious signs of damage, never had liquid anywhere near it, any ideas what might have happened? Did find a cobweb inside, and some damp on the outside of the side panel, but the inside is bone dry :confused:.

TIA,
ng93
 
Full specs:

2500K (at stock) with corsair a70
6950 toxic (unlocked shaders and factory overclocked)
msi p67-gd53
antec true power 650 (though these were supposed to be good!?)
a few hard drives
corsair force 3 ssd
8gb corsair vengeance lp (2x4)

By the time I got the side panel off the smoke had gone, i think there was a tiny bit left above the hard drives but no idea if it was coming from them. Had the computer for nearly a year no problems (well quite a few F4 BSODs but a reinstall made them much less frequent). Smoke came out the top so don't think it would be the psu which vents out the back? Had a look around but can't see anything wrong, no burn's or anything.

Is it safe to try turning it back on to see what the problem is?
 
Looking at it now there's nothing blown on the motherboard, no loose wires (some loose sata power cables round the back but they shouldn't short?), all the cables are properly plugged in, nothing loose, shouldn't have overheated as wan't doing anything intensive and I could hear the fans working. No burn marks anywhere.
 
Can't see much because of the shroud, but what I can see on it looks fine (same with the psu). Not sure what else I can check? Hard drives and dvd drives all seem fine. So does the ssd. Everything looks good :confused:.
 
Just had another look at the hard drives:

o0q6gz.jpg


Take it that's the culprit? Or could this be a PSU issue?
 
No wires or anything near it, the drive that was above it has a slightly burnt power connector, but doesn't look to be broken. The drive below has no marks what so ever. Just worried that it was caused by a faulty PSU, anyway to check?
 
Well started it up with just the CPU and GPU and it posted fine, tried again with a couple of drives and a Ubuntu live cd and everything seems fine. Won't boot Windows for some reason, but I'm guessing pulling the power caused that?

Going to RMA the hard drive which caught fire and the one it damaged. Is it worth RMA'ing the PSU as well just to be safe?
 
The cables and PCB look fine (nothing else near the drives). Is it possible that something inside the drive was damaged?
 
Hi again,

The hard drive which was above the one which caught fire has slight burn marks on the power connector but is working fine ATM. Is it likely to have been damaged? Worth sending back and trying to get a replacement?

Thanks
 
It is unlikely they'll accept it back unless the marks come off. Run a full battery of tests on it, if it passes them all then its likely fine.

Obviously would pay to backup your data regardless and inspect the connectors the two drives were plugged into. Maybe switch to some others on the PSU to be on the safe side.

Ran an error test with hdtune and it says everything is fine, but when I go to the health tab nothings there, dispite the fact that the drive should display health info (Spinpoint F3 1TB HD103SJ). Is this a problem with the drive or possible software/driver issue? PSU/cables look fine. Thanks

Maybe the spider, which made the cobweb, crawled over some live contacts and fried

So spiders can fry computers? Well at least now I have a reason to be scared of them :p
 
Back
Top Bottom