confused on the fully automatic PWM speed control for NF-F12 !!

west1980 · 27 May 2012 at 22:48

could someone explain how would I use the fully automatic PWM speed control on the NF-F12 ?

I have the noctua NH-D14 and swapped the NF-P12 for the NF-F12.

I have no Idea how I would get it to use automatic pwm fan control.

I used the y-splitter cable to connect my NF-P14 and the NF-F12 to the 4pin header on my motherboard.

dont know what to do next?

west1980 · 27 May 2012 at 23:26

I can see sys fan 2 &3 are automatic in bios

west1980 · 28 May 2012 at 14:00

So if I used this one

http://www.overclockers.co.uk/showproduct.php?prodid=CB-071-AK

With my NH-D14 and the NF-P14 NF-F12 Would it not work as pwm unless I had 2 Of the same fans right?

west1980 · 28 May 2012 at 19:19

I have the P67A-GD65 mobo Im not sure what to change in the hardware monitoring section

west1980 · 28 May 2012 at 21:14

there are 2 pwm fan headers on my mobo!

CPU fan & sys fan 1

[/IMG]

how should I set the CPU min.fan speed?

when I check msi control centre all fans are on auto

CPU fan idles around 860rpm

system fan1 idles 857

system fan 2 idles 870

dod I still need a pwm fan splitter cable?

west1980 · 28 May 2012 at 22:17

Take one y-cable and attach it to the CPU fan header ...then attach the noise reduction cables (one on each of the Y splits) Then attach the fans after.

DO NOT PUT A SINGLE NOISE REDUCER CABLE BEFORE THE Y-CABLE!

is that safe that way? attach a noise reduction cable to each Y split?

I have a NF-F12 and a NF-P14 not 2 NF-F12's

is it better to have NF-F12 instead of a NF-P14 ?