Connecting ADSL Modem to router without WAN port?

Associate
Joined
21 May 2003
Posts
1,008
Hi. My router (Belkin F5D7633 adsl modem/router) keeps dropping the internet connection for a minute every so often and it's getting annoying.

I have a Dlink adsl modem which is very stable and want to use it with this router.

How do I set the Belkin up for this? It doesn't have any WAN ports at the back, just a 4 port switch.

I've set the Dlink modem to bridge mode (that's how i had it before when i used a dlink router with a wan port).

And I've set the Belkin to PPPoE mode with the correct username and password but i'm guessing it's just trying to use its internal modem rather than the dlink.

Is this even possible?
 
The dlink is only a modem and doens't have a router mode.

Forgot to mentiont hat hte Belkin is a wireless router so that's why I need it.

I can get the dlink to connect to the internet by itself (putting the username and password into the modem) and it works fine with my computer plugged into the modem.

surely then if i plug my computer and the modem into a router they would be joined and should work?

Otherwise the only other option is to use my dlink router (which has a wan port) to connect the modem to, then connect the dlink router to the wireless belkin router.

is this the route i'm gonna have to take without changing the belkin router?
 
it's the dsl-300G+
I'm pretty good with computers (just not with complicated networks) so if there is a russian solution then it';s a good one!

I still dont understand the theory though. Say the modem is in router mode, why would i have to stop the belkin from being a router? (and how will wireless comptuers connect to the internet through the belkin if it's not acting as a router?)
 
ok, well *** dlink modem doens';t have an option to turn it's DHCP server off.
and there are no other settings that I can configure with it like sending ports to certain comptueres etc (which the belkin can do).

so in an effort to keep the belkin's dhcp capabilities, can i not just switch it to use 10.0.0.1 as the addrss? the dlink uses 192.168.0.1 (and i can't change it), so surely they'll be hidden from eachotehr as they're on a differnet subnet mask?
 
sweet! cheers for htat it's all sorted now.

Here's the setup:
Dlink modem set to bridge mode (192.168.0.1)
connected to Dlink wireless router (192.168.0.1) which has DHCP enabled and wireless disabled (really bad range, that's why i bought the belkin in the first place).

and also connected to the dlink wireless router is the belkin wireless router (10.0.0.1) with DHCP disabled and wireless enabled.

Now all the settings for routing is done through the dlink (which is good becuase the Belkin forgets what ips i've assigned to what mac addresses after a reboot - useless for port forwarding), and the £55 Belkin Wireless router/modem is being used as just a wireless access point which is all it's good at and the only thing the dlink is not so great at.

So I've got three boxes all sitting next to eachother, each with their own big brick adaptor. Saved me the £120 I was gonna spend on a DG834N (see thread about wireless router suggestions).

thanks!¬
 
Back
Top Bottom