Connecting my Asus Aura Motherboard to Bitfenix Enso Mesh RGB controller?

[Iamzod]

I have an Asus Aura motherboard with 3 pin ARGB header in a Bitfenix Enso Mesh which states it's Aura Sync compatible. There are however no instructions with it on connecting it up.

The Controller has a cable coming off the front panel that goes into the RGB controller, it also has an empty female ARGB 3 pin connector hanging there.

However there is also some other type of 3-pin connector which is also empty.

My confusion comes from the fact that none of this is labelled & the cable to connect from the motherboard to the controller is a Y shaped cable & has both plugs on it.

Where do I connect it without something going pop?

 

[Iamzod]

Just realised that the RGB front panel lighting can be disconnected entirely from the controller & leaves a female Aura connector free, i presume I can simply connect this to the RGB header & ignore the case supplied RGB controller entirely?

 

[Mikeru]

Just realised that the RGB front panel lighting can be disconnected entirely from the controller & leaves a female Aura connector free, i presume I can simply connect this to the RGB header & ignore the case supplied RGB controller entirely?

Hi.. you can solve? I had the same problem,... in the official page says "long press buton" but is not works..