Corsair Dominator RGB and iCue

Matt72033

Matt72033

Matt72033

Associate
Joined
28 Sep 2020
Posts
315
Does anyone else have issues with this RAM and iCue?

More often than not when I load up iCue there is a red exclamation mark triangle next to the ram, and sometimes it doesn't show up at all. Then the ram just sits there on whatever setting it was on previously.

Any ideas?
 
Hi Mate

Thanks for the reply. Yeah I've force updated the firmware a few times, it usually works ok after that for about 15-20 mins.

I do have the Asrock RGB software running, and I think this maybe causing the issue.

It's so frustrating that it can't just work! :D

To be fair, its not awful, when it stops working it just defaults to a set colour from the pattern I've chosen, so its not massively out of place. Its just annoying
 
Mongole0 said:
Might be worth checking the DRAM voltage is correct.
I did not have any whine, but when I installed 4 sticks on standard voltage (1.2V) the motherboard was chattering a bit on start up. I upped the voltage to the specified level (1.35) and it went away.
Click to expand...
Yeah just checked and it’s at 1.35

shame, that would have been a nice fix :D
 
Starting to get fed up with this ram now

2 sticks now just go into rainbow puke mode when I turn the PC on, have to restart to get them to sync with the colour settings of the other 2 sticks.

I might start looking at alternatives
 
following a DRAM failure reported by the motherboard OLED last night, I've returned these for the second time.

Gone for some vengeance pro 3600mhz instead. They seem to be fine in my daughters rig
 
You must log in or register to reply here.
Back
Top Bottom