CPU reading diffrent speeds at the same time & GTX temps

[PTG]shogun · 20 Dec 2007 at 15:45

I have OCed my q6600 to 400X8 in the BIOS this is what is read under load by CPU-Z. But 3dMark, coretemp, speedfan DXDIAG and most programs (even vista itself) reads it as 3.6 insted of 3.2 (coretemp tells me its 450X8). I have the Vcore @ 1.4V and have added minimum +v to northbridege and FSB.

could my MB be adding these 50Mhz to the FSB? IDK

Also i used expertool to take my OcUK 8800 GTX to BFG OC/OC2 levals
i have it clocked to 615/1900. Idel its about 64 degrees. after running 3dmark06 (all the tests it has on it) over and over again a few times The max temp i got the GTX too is 75. Is that good? normal? bad?
(FYI the 3dmark results were all about 12700 CLICKY IF IT WILL HELP)
what are the temps for a GTX on load an idle?

TIA

Pneumonic · 20 Dec 2007 at 16:13

CPUZ is reporting correctly the others are not

75c is fine on the GPU they are far more tolarent to heat than the CPU

[PTG]shogun · 20 Dec 2007 at 19:34

any idea why the rest are giving bad results?
If 75 is fine on the GTX then can i push it further?

I know its a lot of questions but the more asked the less next time round

Pneumonic · 20 Dec 2007 at 19:40

I believe the other programs are assuming a default *9 multiplier on the CPU whereas CPUZ checks this...

I am really not to knowledgable about graphics cards but I believe in the graphics card part of the forum people have reported temps of over 90c (would go have a look there!

)

[PTG]shogun · 20 Dec 2007 at 23:09

hmm Its saying its 450X8 insted of 400X8

taken my GPU to 640/2050. Hits 82 when under load occasionally but usually under load its about 78-80. 3Dmark06

Pneumonic · 20 Dec 2007 at 23:16

well i shouldnt worry mine does exactly the same on a non *9 multiplier