Dell Perc 6

GodAtum

GodAtum

GodAtum

Associate
Joined
27 Sep 2009
Posts
1,693
Hi all,

I have installed a Dell Perc 6 and covered the 5/6th pins. My server now boots up but misses the Perc boot screen and goes straight to EXRI. Any ideas?
 
Last edited:
I have an Gb g1 Sniper 3. The Sata mode selection is set to ACHI not RAID. The marvel ata config is also set to ACHI. There is stuff about boot mode selection set to UEFI and legacy.
 
Yes it would not boot properly. I covered the front side of the 5/6 pins. Do i need to do the back side as well?
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom