Display Driver Stopped Working And Has Recovered

stufflol · 27 Mar 2014 at 20:29

Just got an error message on my Inno3d GTX 780 ichill whilst playing CS:GO. Its brand new the drivers are up to date etc. what could be the issue here? or does it happen once in a while with new cards? this maybe a silly question just dont wanna end up with a faulty card.

PS I had the inno tune it app boosting the card 10% if that might be any problem

Any help appreciated

Thanks

stufflol · 27 Mar 2014 at 20:48

Any Ideas?

Max temp has been like 45 degrees c

wazza300 · 27 Mar 2014 at 20:54

does it do it without the boost? usually its unstable if driver stops/recovers

Avenged7Fold · 27 Mar 2014 at 20:55

My display drivers usually crash when the Core is not stable. Could pump up the core voltage a bit to see if it helps?

Do you only get it with CS:go?

If it turns out to be unstable at stock, i would RMA it rather than pumping up voltage to keep it stable at stock.

stufflol · 27 Mar 2014 at 20:59

It has happened once whilst playing CS go on ultra settings with the inno 10% boost setting on. I did get a warning that it could make it unstable using the 10% boost but thought I would try it, I will run it without the inno software for a few games and run heaven for an hour see if it happens again.

Is there any way I can see the error written anywhere or do I have to constantly be looking to see if it happens again? (whilst running heaven)

Would I be ok to run heaven for 5 hours and see if it has any issues on ultra settings?

If I tell you the voltage might you know if its enough?

Also, alt+tabbing whilst the boost was on caused frame drops, with out it alt tabbing is very smooth

Avenged7Fold · 27 Mar 2014 at 21:33

Voltage varies from chip to chip, so couldn't tell you if it is enough. 4 or 5 runs of heaven on max settings usually will cause it to crash if it is unstable.

stufflol · 27 Mar 2014 at 21:35

ok, is it possible to see an error report? so I dont have to sit and watch 5 runs of heaven?

Doogles · 28 Mar 2014 at 00:07

Not sure if this is helpful or not but CS:GO had a update earlier on and I was getting terrible microstutter in game with a pair of HD 7850'. About 2 hours ago there was another patch and the microstutter has gone away so maybe that has something to do with it?

stufflol · 28 Mar 2014 at 09:55

Didn't update it yet, will try tonight.

Basically I think the Inno 10% boost setting is not configured correctly. perhaps it isn't raising the voltage to match the boost in speed or something making it unstable..

When I have a 2% boost on the voltage is 100% still should this not be 102%? to match the boost?