Does this look ok

Griff7520

Griff7520

Griff7520

Associate
Joined
2 Jul 2007
Posts
2,215
Location
Cheshire East
Hi



as the question says....does this look right for a LCS set-up, temps voltage etc etc.....i can not get over 3.6 but i think it is the memory holding me back. I am running Geil 6400 ultra....would some pc8500 be better and if so what would i have to set the fsb to get 4.0 cpu speed...thanks in advance for any advice
 
You could try slackening the memory timings to see if the memory will go a bit further, and maybe increase VDIMM. Might be better to try that than buy pc8500 and find that the CPU was the limiting factor. If you really wanted to find out if that the memory's max speed you could: downclock the CPU(so you know its well within it's limit) , use a higher memory divider and find a point where the memory is again running at 450mhz. From there you could slowly increase the CPU speed and see what happens.
 
Last edited:
mame said:
You could try slackening the memory timings to see if the memory will go a bit further, and maybe increase VDIMM. Might be better to try that than buy pc8500 and find that the CPU was the limiting factor. If you really wanted to find out if that the memory's max speed you could: downclock the CPU(so you know its well within it's limit) , use a higher memory divider and find a point where the memory is again running at 450mhz. From there you could slowly increase the CPU speed and see what happens.
Click to expand...

thanks for that....will give it a go
 
You must log in or register to reply here.
Back
Top Bottom