Double BSOD

kellaway225 · 5 Apr 2010 at 11:36

So i updated my BIOS last night and everything seemed fine, today not so much within 5-10mins of turning on the computer i have gotten 2 BSOD both different and both none of which i have had before they are :

Page_Fault_In_Nonpaged_Area, Code : 0x00000050
Kernel_Data_Input_Error, Code : 0x0000007a

looking online it seems the first could be down to hardware fault, bad driver install (guessing BIOS - but was fine last night?) but not too sure about the other in either case, what should i do - is it possible to go back to the pre-BIOS update? and see if everything runs fine, i dont see why it would be that but thats the most recent thing i have changed - could be RAM fault but that has been fine since i got it and strange that it would become defective the day after i do a BIOS update

Anyone have any ideas?

Spartacus35 · 5 Apr 2010 at 11:46

Seems to me it's either a hard drive error, a memory issue or bad BIOS update or even that you have some hardware that the BIOS simply can't communicate with properly. Anyone else got any ideas?

kellaway225 · 5 Apr 2010 at 11:51

I was thinking the BIOS as well, as it was the only that i recently changed
but it worked fine last night but not now - however i am running in Safe mode and dont have any of the above error messages appear yet

How can i revert back to the BIOS i was on last night?

Randomface74 · 5 Apr 2010 at 11:53

do you have an SSD?

kellaway225 · 5 Apr 2010 at 11:55

Nope, i just have a F3 1tb drive, which is under a month old - like the whole computer

Randomface74 · 5 Apr 2010 at 11:58

check your ram speeds and voltages. if they match what you expect, put a bit more V into it - sometimes that can keep it going.

kellaway225 · 5 Apr 2010 at 12:04

would a BIOS update reset the voltages? as i had to up the RAM voltage on the last BIOS
running in normal now - no BSOD yet

kellaway225 · 5 Apr 2010 at 12:14

i ran a hardware check on the hard drive didnt report any bad files so i guess thats okay
i had to manually reset the voltage back upto 1.65v as it was set at auto again - maybe that will stop the errors?

fastwunz · 5 Apr 2010 at 12:16

kellaway225 said:
i ran a hardware check on the hard drive didnt report any bad files so i guess thats okay
i had to manually reset the voltage back upto 1.65v as it was set at auto again - maybe that will stop the errors?

the errors you refered to were memory errors- i think you may have solved your problem

kellaway225 · 5 Apr 2010 at 12:20

Thats good, i wonder why i didnt get any last night? maybe because i didnt reboot the computer? but if those problems were there why not give me the errors last night? I did have a feeling it might have had something to do with the BIOS as that has been the only thing i have changed - not including adding the few extra fans and blue LED "Bling"

Randomface74 · 5 Apr 2010 at 12:37

sounds good, see how it goes.

kellaway225 · 5 Apr 2010 at 12:39

So far no errors, within 10mins last time i had 2 x the first error and 1 of the second error
so maybe its fixed which is good news