Soldato
- Joined
- 18 Oct 2002
- Posts
- 7,052
- Location
- Kuala Lumpur, Malaysia
Hope someone here can advise 
We've got a newly installed leased line - this comes with a Cisco 1921 router, which then connects into a Draytek 2960 (WAN1)
I've been given details from ISP which settings to use (WAN IP, Subnet mask, default gateway, LAN network address, broadcast address etc.) and just trying to figure out how to get the connection up and running.
WAN IP is active if that matters - can be pinged from outside network.
So far just added in the details that are available - set IPV4 Protocol to static and set WAN IP, Subnet Mask, Gateway IP and DNS, however shows no connection.
Anything obvious I'm missing here?
Thanks in advance
We've got a newly installed leased line - this comes with a Cisco 1921 router, which then connects into a Draytek 2960 (WAN1)
I've been given details from ISP which settings to use (WAN IP, Subnet mask, default gateway, LAN network address, broadcast address etc.) and just trying to figure out how to get the connection up and running.
WAN IP is active if that matters - can be pinged from outside network.
So far just added in the details that are available - set IPV4 Protocol to static and set WAN IP, Subnet Mask, Gateway IP and DNS, however shows no connection.
Anything obvious I'm missing here?
Thanks in advance