Dreytek Vigor 2820 - Config

Burnsy2023 · 19 Oct 2010 at 11:53

I want to configure this router to route traffic using two internal gateway addresses (192.168.10.1 and 192.168.11.1). I want both to be routed rather than translated via NAT. How do I do this?

Toughnoodle · 19 Oct 2010 at 14:39

Good question. I don't think this is the right bit of kit. It sounds like you need to route between two ethernet networks rather than anything to do with Internet access. Someone else may be able to suggest some basic Cisco kit...

Burnsy2023 · 19 Oct 2010 at 14:41

Toughnoodle said:
Good question. I don't think this is the right bit of kit. It sounds like you need to route between two ethernet networks rather than anything to do with Internet access. Someone else may be able to suggest some basic Cisco kit...

Dreyteks have a decent cli IIRC, it must be possible.

Toughnoodle · 19 Oct 2010 at 15:38

I'm not sure how you could assign IPs to ports (i.e. the default gateways of the networks). I've always I had the impression that inside the box it's a 2 interface router (ADSL/Ethernet) internally connected to a small switch.

Curiosityx · 19 Oct 2010 at 16:27

I dont think is possible as under the LAN configuration you can specify a primary and secondary network, the primary is typically subject to NAT and the secondary a routed interface.

What happens if you specify the two private networks listed above in the primary and secondary fields?