e5200 overclock

rob_banks · 20 Jun 2009 at 04:23

does any 1 have any good settings to put into my bios plz

ii could only get it up to 3ghz when i tried 3.2 it crashed

all i was changing was the fsb

can some1 tell me what settings to use plz

id be really gretafull

im a noob u see

any help is much apprecited

can u tell me what i need to enable / disable

ram timings voltages all that good stuff

oh and at 3.0ghz i was on 53c load temp

hawker1986 · 20 Jun 2009 at 07:42

What motherboard do you have and have you tested its stability using prime95/intel burn test?

Hawker

rob_banks · 20 Jun 2009 at 13:49

hi thx for your reply

i have a p5q-e and it past 1 hour of prime 95 before i switched it off

rob_banks · 20 Jun 2009 at 17:15

can anyone help*?

Bradley8988 · 20 Jun 2009 at 17:50

What voltage is your CPU at now underload? CPU-Z will tell you.

rob_banks · 20 Jun 2009 at 18:20

ok update i set everything to auto aprt from

multi which is x11
and fsb which is 300
and cpu voltage is at 1.280 in cpu z
everything else is on auto

im 20 mins in so far prime 95 stable fingers crossed

oh and my temps are 57- 58 celsius

rob_banks · 20 Jun 2009 at 18:23

i heard it s good to set your ram ratio to 1:1 then only raise your fsb and voltage to the max (1.325) it can take with out bsoding

is this true if so how do i set my ram to 1:1

also i have everything aprt from what i mentioned baove on auto

is this ok ?

Bradley8988 · 20 Jun 2009 at 19:01

What speed is your ram running now? CPU-Z will tell you this under the memory tab. Temps are fine

rob_banks · 20 Jun 2009 at 19:37

ok update 3.33 lasted 1 hour prime so i decided to up the fsb but it failed prime in 1 sec

so i upped cpu volts to 1,304 in bios and the fsb to 310

so im 8 mins into prime at 3.4 so far

load temps 59 61

oh aND MY DRAM FREQUENCY AT 3.33 WAS 500,mhz

and now it is 516.7 mhz

how are my temps ?

any advice ?

Bradley8988 · 20 Jun 2009 at 19:46

temps are still fine. Try keep your ram lower that its rated speed until you max out your CPU clock then sort the ram out.

rob_banks · 20 Jun 2009 at 21:48

ok update

im at 11 x320 mhz for 3.5ghz

and i cant get past here im stuck

i passed 1 hour of prime 95 at 1.360 volts at 3.5 ghz reported in cpu-z

are these volts ok ?

as with before everything is on auto apart from multiplyer,fsb dram volts and cpu volts

my load temps are 63-64

is this ok ?