E6300 First OC

Lethal` · 16 Feb 2008 at 16:26

I have had a go at ocing my e6300 today and currently have it at 2728mhz.

Running orthos for only about 4mins now but temps are at 60C according to Coretemp. I left vcore on auto and set my fsb to 390, these temps seem quite high already and im not sure if it is safe to go further?

What steps should I take next, and can I get the temps lower in any way?

Lethal` · 16 Feb 2008 at 16:34

Im not saying your wrong in anyway just asking. Whats the reason for setting it to 1.425v?

Lethal` · 16 Feb 2008 at 16:48

Wow that made a difference :

What should I do now, just go for 2.8? Thats my aim

Idle that was about 40C

Lethal` · 16 Feb 2008 at 17:09

On 2.8Ghz will run full orthos overnight later.

How does it look? What are your suggestions for me to do now?

Lethal` · 16 Feb 2008 at 17:15

Yep im not sure what to do at this stage in regards to memory. The guide in the sticky doesnt go in depth into memory
Can anyone link me to a more in-depth guide?

Lethal` · 16 Feb 2008 at 21:40

Thanks but How do I do that IAmATeaf ?

Lethal` · 17 Feb 2008 at 07:28

I have an Asus P5B-E

Lethal` · 17 Feb 2008 at 15:05

I still dont really understand how I can go higher as I will have to adjust memory, i have pc2-6400 stuff. Can anyone help?

Lethal` · 17 Feb 2008 at 15:13

So can I just up the fsb even though I have reached 400 already without editing memory settings first?

Lethal` · 17 Feb 2008 at 15:36

Would seem a bit high if that is idle, load would be 60+

Lethal` · 18 Feb 2008 at 22:46

IAmATeaf said:
Set you memory multiplier to 2 then start ramping up the FSB

Hmm... I went into my bios and looked for a setting where I can change the memory multiplier but could not find it. Any ideas? And I presume setting that to 2 overclocks the RAM?

Lethal` · 19 Feb 2008 at 16:37

Anyone?