Hi,
I bought my new system from overclockers about 4 months ago, but I hadn't yet looked into overclocking or temps at all, I just figured they'd be fine as I have a Noctua NH-U12F on an E6750 @ 2.66GHz. I managed to overclock to 3.2GHz without much of a problem but I don't need the extra speed at the moment, so went back to stock. Temps @ 3.2 were reaching about 60 deg C (Core temps under load) and then levelling off, though it didnt seem to be throttling. However, i've found at 2.66 the temperatures are much the same under load, and my machine is at about 40 deg idle (both cores). This is a little hotter than I would have expected, any ideas what might be wrong? Here's the setup:
E6750 @ 2.66GHz with Noctua NH-12UHF
GA-P35C-DS3R (rev1.1) F10
2 x 1GB GeIL 6400 Ultra
BFG 8800GTS 320mb OC2
250GB WD SATA-II
Corsair HX 620W PSU
Akasa Zen white case (2 x 120mm 1 front, 1 back)
I used the supplied thermal paste for the cooler, and installation seemed fine, I have checked it since. The cooler isn't dusty either.
Could the case be to blame? The case temp is around 35 deg idle, maybe it is not enough to cool the GFX too? Recorded the temps with Speedfan, setup to add 15 deg to core temps, so those should be correct...
Thanks
I bought my new system from overclockers about 4 months ago, but I hadn't yet looked into overclocking or temps at all, I just figured they'd be fine as I have a Noctua NH-U12F on an E6750 @ 2.66GHz. I managed to overclock to 3.2GHz without much of a problem but I don't need the extra speed at the moment, so went back to stock. Temps @ 3.2 were reaching about 60 deg C (Core temps under load) and then levelling off, though it didnt seem to be throttling. However, i've found at 2.66 the temperatures are much the same under load, and my machine is at about 40 deg idle (both cores). This is a little hotter than I would have expected, any ideas what might be wrong? Here's the setup:
E6750 @ 2.66GHz with Noctua NH-12UHF
GA-P35C-DS3R (rev1.1) F10
2 x 1GB GeIL 6400 Ultra
BFG 8800GTS 320mb OC2
250GB WD SATA-II
Corsair HX 620W PSU
Akasa Zen white case (2 x 120mm 1 front, 1 back)
I used the supplied thermal paste for the cooler, and installation seemed fine, I have checked it since. The cooler isn't dusty either.
Could the case be to blame? The case temp is around 35 deg idle, maybe it is not enough to cool the GFX too? Recorded the temps with Speedfan, setup to add 15 deg to core temps, so those should be correct...
Thanks