Electronics question, aluminium as power rail?

Gundog48

Gundog48

Gundog48

Associate
Joined
13 Sep 2009
Posts
1,612
Location
Maidstone, Kent
Long story short, I am building a dummy load for testing PSUs which will consist of a bank of 12x 100W bulbs set up in parallel with switches for each bulb. The design is OK, but it means that the power rail will have to handle up to 100A on full load which would require some thick wire and good homemade screw terminals.

Instead, I had the idea of using an Aluminium strip as the main voltage rail, which I can drill and bolt the switches and bulbs to. Is there any problem with using this method instead of normal wire?
 
I did think that, but the advantage is I can get thick aluminium strips for free! A big ol' aluminium strip has got to be better than 4mm wire surely? Anyway, what mostly concerns me is the fact that it is non-linear. Ie. when using wire, the current is forced along a direct path to each connection, whereas here it isn't forced directly to a connection. It's probably not a problem but I felt I should check!
 
Yeah, the bulbs are 100W car headlights. The advantage is that as they are car headlights they run on 12V just like the PSU, so 1 bulb = 100W load!
 
Yeah, I've got some 500W halogen floodlights and they are bright enough! It will be enclosed in a box but it's sure as he'll going to get hot! At least when I'm not testing PSUs it will double up as a lighting system for videos and photos and a 1200W room heater!
 
Thanks for the quick responses anyway, had a brainwave in the middle of the night and had to post before I forgot!
 
It's going to be set on an MDF base with the rest made out of aluminium sheet. 100W is the total energy, so 100W of light and heat combined. Fortunately I will mainly be testing 700-850W units so it shouldn't be a massive issue. Although I have decided to install the 120mm fan now!
 
stulid said:
why not use the right value resistors, you can do simple calculation to work out what you need, as you know the Amps and Wattage you want to draw.
Click to expand...

That was the original plan, however big power resistors are expensive and need to be kept cool otherwise they break. Also with the lights, some of the heat is being removed as light rather than heat, and the bulbs don't need to be kept cool. I also considered using MOSFET transistors, however they have to be kept even cooler, which I didn't consider a problem until I realised I needed to remove 1200W of heat and my CPU only uses 140W in total! Plus the MOSFETS are more sensitive to heat than a CPU.
 
You must log in or register to reply here.
Back
Top Bottom