Eliminating bubbles

What I did was take the cap off my Res, start the system running so the water was flowing, then tip the case back and forth, also stop/start the pump a few times and you'll find you'll flush a load of bubbles out the Rad.

I did the process of rocking and stop/starting for about 10-15mins and that eliminated pretty much all the bubbles for me.
 
Hiya,

Have you just started the cooling system/refilled ??

If so they should die down after several hours of running (keep eye on water level)

If there's no obvious bubbles that you can see (trapped bubbles in rad or somewhere along the circuit or alike) unless you can manouver the water run around to dislodge the trapped air the only other thing i can think is a stronger force pushing the water eg: stronger pump that forces water so fast through it negates the air a chance of staying trapped (hope that makes sense)

If rad is moveable somewhat you could try different movements to try to dislodge trapped air

I've made sure all my inside of the case was secure and actually held it at all angles to displace trapped air

Hope it helps somewhat

Ciao

Def
 
No worry man

Honest it makes it look like pea soup, They will go after time honest

Got me panicking yrs ago when i 1st made a cooling sytem lol

Ciao

Def
 
You must log in or register to reply here.
Back
Top Bottom