watching my printer I think that if I went dual Z then I could potentially go slightly bigger build plate?
but then if I was spending out on dual Z I would be thinking about the hydra setup as well.
had some fun over the weekend, belt broke! turns out my mix of upgrades had caused it to ride up on the stepper, so I've replaced the rail connections for proper endorphin3d ones. much better now.
yeah, it's because I was trying to half arse it. I'm still thinking that at some point I'll want to go full COREXY.
currently I'm looking at the x gantry, the rail that endorphin3D says is 9mm rather than 12 as it's lighter but that doesn't fit well on the 2020 extrusion.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.