Entho Primo Loop help

Tommyzz

Tommyzz

Tommyzz

Associate
Joined
6 Jun 2011
Posts
406
Location
Manchester
Hey,

I'm really having a problem deciding what way to have my loop. I don't want tubing all over the place and want it to be fairly clean. It's my first time watercooling so I'm struggling to work out the amount of fittings I will need.

I massively underestimated the amount of fittings I would need.

I currently have:
6x Monsoon 16/10 Straight - Chrome
2 x Monsoon 16/10 45 - Chrome
1 x Monsoon 90 - Chrome

29vguhy.jpg

That is the design I'm looking for. The pump will be on the other side in the bottom of the case, opposite to the monsta rad at the bottom.

480mm rad at the top
360 Monsta at the bottom
EK Res x3 250

Will be grateful for your help!
 
Angled fittings are quite hard to plan in advance.

For loop order with the least amount of tubing visible would it be possible to route some around the back of the case behind the motherboard tray. You could then go from the top rad to the pump in the basement.

Or if not use an EK-RES X3 Internal Tube to allow you to connect your res at the top and bottom rather than two tubes coming from the bottom.
 
Disco_P said:
Angled fittings are quite hard to plan in advance.

For loop order with the least amount of tubing visible would it be possible to route some around the back of the case behind the motherboard tray. You could then go from the top rad to the pump in the basement.

Or if not use an EK-RES X3 Internal Tube to allow you to connect your res at the top and bottom rather than two tubes coming from the bottom.
Click to expand...

Using white tops and bottoms for my res so can't do that anyway.


How would I put a drain port on this. Thinking of putting it on the bottom monsta rad but I don't know what fittings to buy.
 
You must log in or register to reply here.
Back
Top Bottom