Enthoo EVOLV Micro fan set-up help

[Holliday]

In the aim to lower my GPU temps I went out and bought 2x140mm fans.

The case has a 200mm intake at the front, 140mm exhaust at the back, then space for 2 more on the roof.

My PSU fan is aimed down out the case so I'm just wondering how to place the others.

Most people seem to say top exhaust, but then that would just leave the front as the only intake with 2 exhausts + psu exhaust. My only other thinking was possibly front and back intake, and then 2 exhaust on the roof. The only possible issue being the GPU is reference so I imagine the hot air might be sucked back in the rear.

Any advice would be awesome.

 

[Danny75]

Or replace the 200mm with the 2x140mm, and sell the 200mm. Nothing at the top so the air flow is smoother.

You may not see any GPU temp improvements either way, especially if it's reference. I doubt that temps are going to improve much with more case fans if you already had the 200mm and rear 140mm* going. But 2x140mm at front should help feed the GPU better than the single 200mm.

* Make sure rear is spinning fast-ish, to extract hot air faster.

Would be interested in the rear/front intake, top exhaust setup results though.