Enthoo Pro M TG running very hot

[doodah]

Well I think I've found out why my CPU and GPU run so hot, my case (idle CPU runs at a toasty 50-55 and GPU under load 80-85). I didn't realise how hot it gets under load, almost too hot to touch. I don't think it was rated as the best airflow case but it does seem to be struggling a lot in this heat.

I currently have my Kraken X52 on the front of the inside with its fans acting as intakes, then a 120 AER on the back and one on the top, both acting as exhausts. My question is should I buy a couple more AER fans as exhausts or get another case with better airflow (in which case, any recommendations for a TG case)?

I have a Zotac AMP 980Ti which seems to run hot anyway so assume it will want as much air flow as possible. Finally should I consider negative/positive air pressures or not important?

 

[doodah]

Sweet, so my current options might be free/cheap. Not actually sure what speeds they are running at, remember setting up a fan curve at some point. Is there any tweak I should do with my X52 radiator sat at the front of the case? I think it goes rad/fans/exterior intake, would this not be bringing in cold air and pushing it through the rad resulting in warm air been pushed across the GPU?

I will take the top exhaust off, reseat the X52 and have a look at the fan speeds/curve.

 

[doodah]

I tried that as my GPU seemed to be running quite hot before the summer, seems that AMPs generally run hotter as reapplying made no difference.

 

[doodah]

Haven't had a chance yet, too much matched betting and football .

 

[doodah]

Hi, sorry still haven't got round to fixing this . Tempted to move the radiator, question though. I have a penchant for RGB so could I put my AER fans on the Kraken X52 and move the non-RGB fans to the front intakes? I am sure I can but would I be sacrificing a lot of performance?