ESXI 6 and PFSense

cellpack

cellpack

cellpack

Associate
Joined
26 Oct 2003
Posts
250
Hi

I am currently in the process of setting up esxi 6

I would like to run the following VM’s

PF Sense – LAN – WAN – Wireless (OPT)

Windows 10 pro

The motherboard has a gig network port

Also I have an intel card with 4 ports

I would like the management port on the mb network port

PF Sense each using 3 ports on the network card

And maybe the windows 10 vm using a separate port on the network,

Any ideas on the best way to achieve the above?

Thanks very much
 
thanks at the minute it has created a vlan within esxi just showing the one card, would i need to create seperate vlans for each port? thanks again
 
ah that may be a good idea, i suppose i could add assign an extra network card to the vswitch0 to increase bandwidth?

i was going to connect a wireless ap to one of the ports so wireless traffic is handled by pfsense also, would i have to create a separate vswitch for that to?

Thanks!
 
I have enabled modem mode on my vom superhub and connected it to my pfsense wan connection

Pf sense doesn't seem to detect the IP address and I cannot browse the net

Any ideas?
 
You must log in or register to reply here.
Back
Top Bottom