This is really weird. Just gone over to water and started re-clocking my chip. On air i struggled to take it past 2.9ghz stable but on water i got it up to 3.1ghz at 1.536v. Anything past this needed big voltage jumps. This then failed a couple of days later right at the beginning of a prime run that before went on for 17hrs before i stopped it. Dropped it back to 13 multi and got it back up again and it did 20hrs stable and now it fails straight away. Havent got any idea why its doing this. Temps are fine and not going over 40 according to core temp.
Chip is fx60 with no ihs
Board dfi expert
Mem Corsair 2gb 3500ll
Psu Tagan u22 530w
Gpu 7900gt extreme
Its just weird that if i drop multi and raise fsb its stable again - the 12 multi just failed at 3.1ghz but after much longer run than with 13 multi
Last thing is that core 0 (stronger core) runs prime tests faster than core1 even though its the same test
Chip is fx60 with no ihs
Board dfi expert
Mem Corsair 2gb 3500ll
Psu Tagan u22 530w
Gpu 7900gt extreme
Its just weird that if i drop multi and raise fsb its stable again - the 12 multi just failed at 3.1ghz but after much longer run than with 13 multi
Last thing is that core 0 (stronger core) runs prime tests faster than core1 even though its the same test
Last edited: