Fan Controller Advice

[Tens]

I got 2 akasa amber fans, front and back, zalman gpu and a zalman cpu cooler.

I want a simple but good (and good looking, with my piano black and silver case (got an antec sonata with a door which it must fit behind ie knobs not too far out))

I dont have any case lights, and dont really mind much noise during the day but i leave my pc on most nights and sleep in same room.

Wouldnt mind a display not that important but want lots of wire length to make it tidy.

Cheers

 

[Tens]

you know the things you get with the zalman gpu cooler, the 4pin molex to the 3 pin, BUT it has 4 3 pin connections, 2 x 12v and 2 x 5v. All i really need is another one of these or a way to make my 1 fan which is running on 12v to 5v.

zalman CPU cooler on the supplied fanmate which i run on its lowest setting
zalman GPU cooler on the supplied 5v cable ot the 4pin molex
Front 120mm case fan on the supplied 5v cable ot the 4pin molex
Rear 120mm case fan on the normal 12v molex connection

Its the last one i have a problem with as its all really really quiet when its not connected.

 

[Tens]

how do you actually move the cables from pin to pin, or i presume you move the actual pin, anyone done this and can give advice?

 

[Tens]

Im not getting a tool to do sommit that i could buying the cable instead. or a fan controller which would do the job too.

 

[Tens]

so i push the lins down into the connector and it pops out?

then i switch them to the setup for the wanted voltage???