Fan Splitter Query (Gelid CA-PWM-03)

pete_agreatguy

pete_agreatguy

pete_agreatguy

Associate
Joined
8 Dec 2012
Posts
186
Location
UK
Hi all,

Quick query:

Using a mATX motherboard that only has 1 chassis fan header but need to connect 3x chassis fans to this header.

Going to use the Gelid solution (PWM 1-TO-4 SPLITTER - CA-PWM-03).

The fans use only 0.2 amps. The motherboard header supports 1 amp in total.

Can I just connect all 3 fans via the fan connectors and not bother with the molex power connector?

Or do I actually have to connect the molex power connector?

Just I'd rather not have all 3 fans running at full speed all the time.

Thanks
 
Last edited:
Are you sure? Images that return when I search show that the 4 pin connector only has two positions populated, which can only be tach and PWM. The Molex, therefore must carry the power.

Provided you plug in 4 pin fans they'll all run at whatever PWM duty cycle dictates.

3 pin fans will run at max speed.

You'd need a 3 pin splitter and lose any PWM control.

Or use a PWM to 3 pin converter.
 
Tealc said:
Are you sure? Images that return when I search show that the 4 pin connector only has two positions populated, which can only be tach and PWM. The Molex, therefore must carry the power.

Provided you plug in 4 pin fans they'll all run at whatever PWM duty cycle dictates.

3 pin fans will run at max speed.

You'd need a 3 pin splitter and lose any PWM control.

Or use a PWM to 3 pin converter.
Click to expand...
Good point - OP says chassis fans which implies 3-pin, but if they're using DC voltage control that will probably stop working
 
Hi guys,

I got directly in touch with Gelid to clarify this. Included my initial message and their reply below:

Dear Sir / Madam,

I would like some clarification on how this product works.

Using a mATX motherboard (Asus Prime B350M-K) that only has 1 chassis fan header but I need to connect 3x chassis fans to this header. The fans use only 0.2 amps. The motherboard header supports 1 amp in total. Can I just connect all 3 fans via the fan connectors and not bother with the molex power connector? Or do I actually have to connect the molex power connector? Just I'd rather not have all 3 fans running at full speed all the time if they can be all controlled by PWM.

Thank you for clarification.
Kind Regards,

REPLY:

Yes you can attached all three fans, they will spin at the same speed, if connected to a PWM header, otherwise they will all spin at full speed

GELID TEAM​
 
pete_agreatguy said:
REPLY:

Yes you can attached all three fans, they will spin at the same speed, if connected to a PWM header, otherwise they will all spin at full speed

GELID TEAM​
Click to expand...

Did they actually answer your question though?

Anyway correct information is already provided above.
 
Last edited:
Your question was actually about the Molex connection, they didn't answer that, and we'd already discussed that topic and brought it to conclusion.

If you are happy though, then that's all that matters.
 
Good point. I'm under the impression I do not need to connect the molex cable; just the 3 fans and the PWM fan header to the motherboard.

You do need to connect the molex cable. My apologies; I missed what was meant by tach and pwm wires above. The power is directly drawn from the PSU as stated on the web site which freddie highlighted above.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom