Few nooby questions

Associate
Joined
24 Apr 2010
Posts
915
Some super noob questions here :D

1. Can I run my radiator at an angle? ie: does it have to be FLAT or does it not matter?

2. How the hell do you get tubing over barbs, it's insane! Does it matter if they're only 1/2 over the barb (as long as it's really tight) or does it need to go right to the end?
 
I tried with pliers, that enabled me to get it on 3/4 but I just can't get it any further. I also tried running it under hot water from the tap before attempting to fit it :/
 
I have G1/4 to 3/8 with 3/8 tubing.

I've managed to get the tubing fitted now. It was really easy once i put a tiny bit of distilled water onto the hose and fitting, easily slipped on then.

I've now got the loop filled, but strangely with 1/4 of a bottle of Mayhems X1. I'm sure that's not right.

It's a CPU, GPU, 360 slim rad setup. Currently attempting to bleed it now.

A few questions: should I be able to see water physically moving? Once the loop became full the water became static. Secondly, any good tips to bleed the system?

Update: got most of the air bubbles out, just little ones left going into the res from the rad and going to the pump. Fluid level still appears the same though.
 
Last edited:
Back
Top Bottom