Filament Dryer Recommendations

[welshdragon]

I seem to have amassed a fair collection of filaments, mostly various forms of PLA that either sit in one of my AMS Lites or in cereal boxes with Dessicant.

However, I am in a converted attic where RH averages about 55%. Though I heat the space when I am in it and have a dehumidifier that I run first and last thing to keep it under control.

I just picked up some PETG and between that and thinking about how I store and cycle between filaments I probably need to consider a dryer.

What dryers do people recommend if I go down this route?

The Creality Official Space PI Filament Dryer Plus is currently £72. Ideally want a dual one but could get 2 singles etc.

 

[welshdragon]

I’ll check that one out, see if I can wait out a discount or something.

Edit: @wafflecart just seen the size of it. Probably going to stick with a two spool solution. Any recs?

 

[welshdragon]

I came to the same conclusion. Picked up the s4 in the end. With two ams lites it means I can drop four at a time to dry.

It’s not as big or as noisy as I was expecting and so far very pleased with it