Gents,
I'm looking to start my first water-cooling loop this week and order the parts, I've done some research read the stickies and managed to develop a parts list for my loop.
I wanted to ask if you could review my list and se if i have made any mistakes or there are any obvious improvements.
NOTE: the case is Corsair Obsidian 800D Full Tower Case and i have a number of 120mm cosair fans available. Also i'm looking for my loop to be very minimalist in design and not have any fancy LEDs or Colours etc. as i have my case out of the way under the desk.
SO here are the parts i'm looking to use;
One question is do have is for the VGA Blocks this is any sort of connector i can get between the two or will they have to have their own separate hose connectors...
So any comments are welcome especially any suggestions for anything i have missed etc....
I'm looking to start my first water-cooling loop this week and order the parts, I've done some research read the stickies and managed to develop a parts list for my loop.
I wanted to ask if you could review my list and se if i have made any mistakes or there are any obvious improvements.
NOTE: the case is Corsair Obsidian 800D Full Tower Case and i have a number of 120mm cosair fans available. Also i'm looking for my loop to be very minimalist in design and not have any fancy LEDs or Colours etc. as i have my case out of the way under the desk.
SO here are the parts i'm looking to use;
- PUMP/RES XSPC X2O 750 Dual Bayres/Pump (Black) V4
- RAD XSPC RX360 120mm Radiator - Black
- CPU Block Koolance CPU-380I Water Block (Intel Processor)
- PSU Bridge XSPC PSU Bridging Connector (24 Pin)
- T-Fitting XSPC G1/4" T Fitting (Black Chrome)
- Coolant Mayhems Ultra Pure H20 Watercooling Fluid 1L x2
- HOSE XSPC HighFlex Hose 7/16" ID, 5/8" OD, 15.9/11.1mm, 2m, Clear/UV x2
- Fittings XSPC G1/4" to 7/16" ID, 5/8" OD Compression Fitting (Black Chrome) x10
- Kill Coil Mayhems Fine Silver Kill Coil x4
- VGA Block Watercool Heatkiller GPU-X³ 79X0 Ni-Bl x2
- For Drain Koolance QD3 Female Quick Disconnect No-Spill Coupling, Barb for ID 13mm (1/2in)
- For Drain Koolance QD3 Male Quick Disconnect No-Spill Coupling, Male Threaded G 1/4 BSPP
One question is do have is for the VGA Blocks this is any sort of connector i can get between the two or will they have to have their own separate hose connectors...
So any comments are welcome especially any suggestions for anything i have missed etc....