First WC finally finish!

yer i know what you mean normally people do go that way tbh

cant say for sure see what the OP says just going on what it looks like to me..
 
bridge looks like its in bottom right to out bottom middle to in second middle to out top right ? would that suggest serial ? cant really see just going from the pattern on the cover
 
okie so looking at the pic you are going anti clockwise then so its

respump > up to the 360 > down to cpu > up to 120 > down to gpu > down to 240 > up to res ?

dunno why i always look at systems and imagine a clockwise rotation
 
Yep that's right, the inlet on the cpu block is on the left.
This has been a massive learning experience.
The gpu bridge is the csq one so I think it's serial, I followed the instructions when fitting it.
 
Yes m8 that's the reaction it's had with the dye. The back of the case sticks out a bit as the extension
Cables have been used. The custom ax850 cables only come with one pcie cable
So I couldn't get the white ones, unless I upgraded to the 1200 which I didn't really want to do.
I'm going to need a bigger case for the next project I think. Any suggestions?
 
looks good and as long as it works fine flow and temp wise doesnt matter what direction you go anyway , i just think its a natural tendency to imagine a clockwise flow for some reason.

so the normal order that people imagine is pretty much there and rads are where you can fit them dependent on case normally ...

masterkleer blue ? it looks like
 
fantasticCG said:
Yep that's right, the inlet on the cpu block is on the left.
This has been a massive learning experience.
The gpu bridge is the csq one so I think it's serial, I followed the instructions when fitting it.
Click to expand...

I take it as your getting 4.6ghz that your flow is fine and everything then? I have the same CPU block and it annoys me having the tubes off my CPU cross over each over to get to where their going so if they can be swapped despite what EK say I think ill do that :)
 
You must log in or register to reply here.
Back
Top Bottom