ga-p67a-ud4 voltage reporting

ArchAnGeL · 2 Apr 2011 at 08:36

What are you using to read voltages on this board. CPU-z and cpuid HW monitor don't appear to read the right results (report 1.08 v when bios is set to 1.31 with load line calibration on). OCCT reports 1.42 V. Bios repots 1.36v

Awahwah · 2 Apr 2011 at 09:04

You must have the B3 revision. HW Monitor will read the correct CPU voltage but it may not appear in the list as CPU volts it may just say CPU.

ArchAnGeL · 2 Apr 2011 at 10:28

Ok I see it under cpu. Reading 1.28v which is similar to what hwinfo32 is reporting as vcore.

I do indeed have the B3

Thanks

postmanfw · 5 Apr 2011 at 00:51

Easytune that comes on the disk with it also read the vcore correctly.

With my UD7-b3 its the only program that will