I suspect I am being a right plonker but on my new build (first one) why is the RAM showing as 3200 in the bios?
The CPU is a E6700 which I have mildly overclocked - to 3.00 until the graphics started blinking on and off.
I have set the timings to 44412 and increased the voltage to 2.1.
Temps look ok 46-48c.
Additionally, I had clocked the 7600 fairly mildly (can remember but considerably less than has been seen on here). It was fine for a couple of days playing BF2 but yesterday on ending he session the display started blinking on and off.
Reset sorted that until I used the NVida control - did nothing but the same sympton occurred. Reduced the clock further - no difference and then to stock settings. Its ok but have not stressed it since.
Anyway you can probably guess I think the RAM is the issue. Any help greatly appreciated.
Ta
The CPU is a E6700 which I have mildly overclocked - to 3.00 until the graphics started blinking on and off.
I have set the timings to 44412 and increased the voltage to 2.1.
Temps look ok 46-48c.
Additionally, I had clocked the 7600 fairly mildly (can remember but considerably less than has been seen on here). It was fine for a couple of days playing BF2 but yesterday on ending he session the display started blinking on and off.
Reset sorted that until I used the NVida control - did nothing but the same sympton occurred. Reduced the clock further - no difference and then to stock settings. Its ok but have not stressed it since.
Anyway you can probably guess I think the RAM is the issue. Any help greatly appreciated.
Ta