Associate
- Joined
- 24 Jun 2003
- Posts
- 1,647
I have just put together the follwing :
abit ip35 + Q6600 +
GeIL 2GB (2x1GB) PC2-6400C4 800MHz Ultra Low Latency DDR2 Dual Channel Kit (GX22GB6400UDC)
now i am in the process of overclocking it,,and have found that i have to test it with 1 stick ,,as everytime i clear the cmos after every o/c failure that because it defaults back to sill Voltage for the ram , that i was going to constantly have to remove 1 stick to get it to boot ,,then change the ram voltage back to 2.1v
is there any way around this ?
Btw now the Q that i origanally started this thread for
i have changed the timings to 12-4-4-4 and voltage 2.1 , should these be at 1T or 2T ??
abit ip35 + Q6600 +
GeIL 2GB (2x1GB) PC2-6400C4 800MHz Ultra Low Latency DDR2 Dual Channel Kit (GX22GB6400UDC)
now i am in the process of overclocking it,,and have found that i have to test it with 1 stick ,,as everytime i clear the cmos after every o/c failure that because it defaults back to sill Voltage for the ram , that i was going to constantly have to remove 1 stick to get it to boot ,,then change the ram voltage back to 2.1v
is there any way around this ?
Btw now the Q that i origanally started this thread for
i have changed the timings to 12-4-4-4 and voltage 2.1 , should these be at 1T or 2T ??