GPU fan speed control

AJUK · 19 Jun 2009 at 08:19

Justgot one of those shiny new Titan Nero systems and am very happy with it. Works great under Vista etc. but the Asus Radeon 4850 needs to run the Asus Smartdoctor software to control the fan speed and therefore noise levels.

I dual boot with Ubuntu 9.04 64bit and when I do the fans run full blast and is very noisy. I have the latest flgrx with the Catalyst controller running yet I cannot control fan speed. I know ATI stuff is pants with Linux but that is what I have got so I was hoping if someone had a solution.

I have looked over other forums but ideas seem lacking. Any help?

AJUK · 20 Jun 2009 at 13:24

Thanks, I'll give it a go.

AJUK · 20 Jun 2009 at 13:54

Tried that before, it didn't seem to make any difference. I'll have another look though, thanks.

AJUK · 21 Jun 2009 at 19:21

aticonfig didn't work and after reinstalling flgrx I discovered that there is no overdrive in the Linux version.

Thanks anyway.

AJUK · 21 Jun 2009 at 19:50

I will keep hacking away until it works. I am going to remove all proprietary drivers and try again, I may even just wipe the partition and fresh Ubuntu install.

Thanks for the help.

AJUK · 21 Jun 2009 at 22:05

Right, I have got it to work but only manually from within terminal using "set fanspeed" and I have adjusted by lowering the speed and temperature checking until I have a comfortable level. It is a lot better but I would be happier with some kind of automatic controller.

Getting there though, thanks again for the help.

AJUK · 22 Jun 2009 at 08:06

Because the fan noise is horrendous!

AJUK · 22 Jun 2009 at 13:13

The fan speed is controlled by the BIOS, as it is in Windows. It is too loud in both systems but in Windows I installed Asus Smartdoctor that automatically adjusts the fan speed; without it it is just as loud.

You are right, around the 30% fan speed mark is quiet and the temp is mid 30 degrees C, so I will have a look at altering that file. Cheers.