GPU foldy help

rincinDub · 2 Feb 2007 at 20:37

Ok, Got my new ati 1950 today, with the intention of doing some folding on it. I have downloaded the correct drivers 6.10. I have installed ati tray tools, with the intention of setting it on to 3d mode manualy. But im stuffed if I can do it. I have followed a guide, but when I click on hardware, I have no 2d/3d detection.

I have still started the gpu, but im assuming it is in 2d mode. Can anbody help me to change it into 3d mode.

rincinDub · 2 Feb 2007 at 21:04

Thats a nice guide, but Im stuck on that one as well, because my ATI tray tools , doesnt show the same options.

rincinDub · 3 Feb 2007 at 14:43

Ok thats interesting. I shall wait until I have completed this wu, then I shall change my drivers. thanks

rincinDub · 3 Feb 2007 at 16:44

Changed back to 6.5 drivers, but my 1950 did not like them. I noticed on the ATI website that 6.10 does support my 1950 pro, so I installed them again. Still no luck on the ATI tool tray problem, but looking on the FAH website other 1950 users are getting similar unit times to mine. So Im assuming 13 minutes a frame is ok

rincinDub · 3 Feb 2007 at 17:53

Not sure without checking, but I did try them, but all I got was some eue. So i guessed i best go back to 6.10.

Just checked, 6.13

rincinDub · 3 Feb 2007 at 20:42

There is a sticky on the FAH website, advising not to use these, even though they all thought these would be compatable.