H60 installation

c61ll · 6 Mar 2013 at 20:11

Getting a h60 delivered tomorrow, any tips on fitting them that i need to know?
Also I have an SP120 performance edition to fit onto this. could i run this along with the stock fan in push/pull or will i be best off sticking with the single sp120?

c61ll · 7 Mar 2013 at 16:23

Its the 2013 edition

c61ll · 7 Mar 2013 at 16:26

Do i connect the pump to the cpu fan on mobo then run the radiator fan direct off a molex or case fan on mobo ?

Also Is it best to have as an exhaust?

Thanks

c61ll · 7 Mar 2013 at 16:36

Thanks for the links. Off to install now and hopefully my backplate is fine.

c61ll · 7 Mar 2013 at 17:04

Seem that the radiator will not fit directly to the case. The part of the case that the expansion cards go into is in the way. Looks like having it as an intake. Or am I doing something wrong?

c61ll · 7 Mar 2013 at 18:44

After reseating a couple of times due to one of the riser screws being slightly bent finally got fitted. Temps are a little higher than my gelid though so not good. Think i will have to replace the TIM and re seat again.

c61ll · 7 Mar 2013 at 18:46

After 20 mins prime 95 my max temp is 80 degrees. My gelid had max temps of 78 degrees after a longer run on prime.

c61ll · 7 Mar 2013 at 19:33

my idle temps are between 21-26 with speedstep on

c61ll · 11 Mar 2013 at 10:41

Re seated the h60 with ic diamond. The temps are a lot better.

Running the 4.4ghz auto overclock i am now getting these results:

Now testing a manual overclock of 4.5 on lower vcore, temps so far are good:

How long should i run prime to test stability?

c61ll · 11 Mar 2013 at 10:59

Passed 10 runs of intel burn test on standard. temps were at 60-68-70-64 max.