HAF-X side panel mod.

Rossdh

Rossdh

Rossdh

Associate
Joined
13 May 2009
Posts
803
Location
Glasgow
Hi folks. Was thinking about getting the new Cosmos 2 but decided against it. Instead, to freshen things up, I was thinking about sending my HAF-X side panel away to get a full size window laser cut and get a couple of custome backplates made up for my GPUs? What do think about the side panel though? Should I leave it as it is or get it modded. Also if I get it modded, what colour of acrylic should the window be, tinted black, tinted red or crystal clear? Any thoughts lads and ladettes?

Ross
 
If I were getting a window cut for the haf-x, i'd run it from the rear to the drive bays and down to the top of the psu.

Lose the big fan and run the vga duct instead.
 
That's kinda what I was thinking. Loose the fan just get it cut around the design that's on the panel.
 
Not quite what I was suggesting!

Essentially all you want to see is the mobo tray so the window would go up a little higher, stop further up from the bottom, and no go as far towards the front of the case.
 
You must log in or register to reply here.
Back
Top Bottom