Handlebar ends

Stovepipes · 30 Dec 2015 at 06:07

I was riding to work and felt something hit my foot. Didn't notice until I parked up that the bar end was missing. I think I'll just get some cheap Puig ones I assume they just screw in and that's it but is there any way to prevent this from happening again, do I need thread lock or something?

Stovepipes · 30 Dec 2015 at 16:45

Yeah it's a NC700s. I was thinking of taking it back to the Honda dealer as they put on Heated grips a few months ago and I assume they didn't put thread lock on and I wasn't aware that I needed to keep an eye on it hence it's worked it's way loose.
I've ordered the Puig ones as it looks like they just come with a long bolt that just screws in rather than having to replace it with the expanding one hopefully it's a nice simple job.

Cheers.

Stovepipes · 30 Dec 2015 at 21:01

ConTRo13R said:
Get some R&G bar ends and use a lot of threadlock. I lost one of mine the other day.. went back the next day and only found the fudger!!!

I almost bought that pair but they're quite expensive. I don't think I'd be lucky enough to find my bar end as it came off somewhere between the Blackwall tunnel and Soho and it's been a few days now.

Stovepipes · 30 Dec 2015 at 22:22

wazza300 said:
You could have bought some cheap Chinese ones? They look decent

I was about to but I wasn't sure they'd fit and I just want an easy life. The Puig ones are branded and a good tenner cheaper than the R&G ones, plus seem to be an easy fit. I don't want the hassle of having to remove, I don't know what it's called, but I'll call it the metal threaded core thingy so hopefully they just screw straight in

Stovepipes · 31 Dec 2015 at 21:20

Dogbreath said:
Do the Puigs have the step in the end that locates into the metal core and prevents the bar end rotating? If not they won't fit properly.

Don't remove the metal part from the bars, it's there to dampen vibration and makes a noticeable difference if you remove it.

Yeah I wasn't planning on removing them for that reason and it looks like hassle. I won't know if they fit properly til they arrive but I've read, on Puig's website I think, that it's a 1 minute job so hopefully it's been designed to be a straight swap.

Stovepipes · 1 Jan 2016 at 21:20

Tefal said:
hondas all have that little notch in them.

just check ebay for generic honda ones (or spend a fair bit and get some really heavy steel ones) use threadlock (blue). you can get cheap ones for less than a tenner.

I found a picture of the ones I think I bought so yeah they look like they'll fit.

Stovepipes · 2 Jan 2016 at 10:21

Tefal said:
doiesnt look like they have a flat on them>?

A flat?

Stovepipes · 2 Jan 2016 at 17:05

Well that's annoying if they don't have that flat bit as I bought bike specific ones. Guess I'll have to wait and see.

Stovepipes · 5 Jan 2016 at 10:09

Well they came this morning and they have the flat bit

Stovepipes · 6 Jan 2016 at 05:27

Seems like a really heavy, dense plastic.

Stovepipes · 6 Jan 2016 at 13:21

£15.99 so not too bad.

I can see why the old one fell out, they seem to spin because I think the heated grips don't allow them to sit in the slot properly, if that makes sense. Hopefully threadlock will mean they don't fall out again.