Hate my Scythe Ninja

Conman

Conman

Conman

Associate
Joined
23 Apr 2006
Posts
152
Mann.... No matter how many time i install it, it is always giving my hard time.
Once i apply the thermal paste and put the Ninja on top of the CPU...
it is abit slipping, i have to hold it with one hand...

Now i have only one hand left at hook the four leg in....
This is the hard part... for the first hook it is fine, second one , i have to use a screw driver to help me push the leg down so i can hook it... then i always bend the aluminum heat sink...
Sometimes the ninja slip... and have to start over again from cleaning...

really... took me more than 1 hr. just to seat the chunk on it.. next time..( i dont know when) i will try to get the most easiest installation HSF ever...

Just want to let you all know before choosing the Ninja... if you are a pro... should be fine but really.... i have been installing it serval time.. still same mistake happens...
:mad:
 
It's a little bit annoying, but once you get the hang of it ok. You should see how frustrated I was removing and refitting Ninja in my MATX TJ-08. Had to take PC apart to remove and refit Ninja (new CPU)
 
Install it out of case is easier.. i remember first time i did that...It just takes more time to reinstall every components plus tidy up the cable as well...

I remember the ref AMD 64 HSF... can pull the lever.. and i am sorted... really i would not mind paying bit extra tenner from the Ninja if it can be installed like the ref. HSF...
 
You must log in or register to reply here.
Back
Top Bottom