Help..overclocking went wrong

Angus02

Angus02

Angus02

Associate
Joined
22 Jan 2007
Posts
338
Until tonight I had a happily running 6600 / Bad axe 2 combo.

But

Whilst trying to get it to pass orthos as 3.6 I read about an item that should
be disabled in the maintance Bios.

So I moved the jumper changed said item saved and came out - reset
jumper to normal and.....nothing it wont post.

I get all the fans spin but No signal / No USB keyboard / Mouse lights and
no HD light - which was always on with the older BIOS I am using.

If I disconect the monitor I get the no signal message up - plug it back and I
get a blank screen.

If I move the jumper again it still wont let me back in the maintance Bios.

A bit stumped now...

I have plugged keyboard / mouse into my old system and both are fine.



Anyone got any ideas / suggestions



Thanks
 
Thanks for the help


Going to try the following

1.Take out Battery - and try again.

2. Recover the Bios through a floppy

3. Just thinkin I remember reading a post about having to put in lower rated
memory to kick start it !! - but the origional ones had no issues at
the time of the build unless they get used to running at 2.0+.


I was nearly at my target overclock at 3.6 now this...going to be a very
grumpy man today.


Fingers crossed.
 
Well all working again :D

Was the RAM issue after all

- took 1 stick out posted no problems

- adjusted RAM volts to 2.2 and put the other one in

- booted no problems


As they say every day's a learning day.


Need to get this thing clocked again :eek:


Thank's for the reply's
 
You must log in or register to reply here.
Back
Top Bottom