Have a creality CR6SE, I've had a few problems over time with prints (who hasn't!) but having installed the community firmware now, I'm starting to understand why!
I've gone under the glass build plate, tightened, and untightened thing under there to try and get a balance but something's out.
The left side of the plate is positive (higher), right negative (lower) which I'm assuming means the x axis on the printer needs adjusting.
Watched the creality video on the adjustment a handful of times and I can't figure out which side to change, nor whether that's the best way of doing it, having a proper thick moment with this at the minute!
I've gone under the glass build plate, tightened, and untightened thing under there to try and get a balance but something's out.
The left side of the plate is positive (higher), right negative (lower) which I'm assuming means the x axis on the printer needs adjusting.
Watched the creality video on the adjustment a handful of times and I can't figure out which side to change, nor whether that's the best way of doing it, having a proper thick moment with this at the minute!
