How to disable Gigabyte Touch Bios Hybrid

Rooky · 7 May 2012 at 20:28

I have a gigabyte GA-Z68 P-UD3 MB on a new build. All was well until I managed to load (without being asked or knowing about it) Touch Bios. I am now unable to boot, enter BIOS or go into safe mode. Shortly after switch on a screen appears with a "Touch Bios Hybrid EFI Technology logo" I am unable to get past this screen and if I touch the keyboard a series of vertical coloured bars appear at the top of the screen. These appear to scroll for a few seconds and then just stay stationary. The board has been overclocked so I don't want to tamper with jumpers or remove the batteries.
Any ideas would be much appreciated.

Thanks

Rooky

smithy83 · 7 May 2012 at 21:16

your overclock has prob failed so your going to have to reset the bios no other way

stulid · 7 May 2012 at 21:21

If the overclock came as part of a bundle, then clearing the CMOS/removing the battery is ok.

You can load the profile back up within the BIOS.

Rooky · 10 May 2012 at 23:30

Thanks for your advice. It was part of a bundle from Scan ( The rest of the build came from overclockers!!) so I will contac6t them and see what they say,
Thanks again
Rooky